Last winter, I had some complaints with my gas furnace… Various rooms in the beach house felt slightly freezing plus adjusting the temperature control had little effect. There were significantly more contaminants circulating in the air plus accumulating on surfaces, forcing myself and others to vacuum plus dust far more frequently. I was convinced that the furnace was making more noise plus supplying less warm air. I noticed that it was starting up more often plus running for much longer cycles. An increase in my daily energy bill convinced myself and others to schedule repair from a local Heating, Ventilation, plus A/C supplier. The serviceman checked the gas furnace plus found nothing beyond a slight buildup of dust on the mechanisms. He then diagnosed the ductwork plus discovered the source of the problems. Leaks at the seams plus an abundance of tiny holes throughout the duct system were allowing approximately twenty percent of the conditioned air to escape, then since the pipes are installed inside walls, ceilings plus the crawlspace, I had no method how repairs would be possible without a major mess. The serviceman then explained a relatively new process called Aeroseal that targets flaws in the ducts from the inside. After blocking off the supply plus return registers, the serviceman hooked up a component that sent highly pressurized air into the system. The air contained adhesive, non-toxic polymer particles. As the air leaked out of imperfections, the particles clung to the edges, steadily built up plus formed an airslender seal. The whole process was completed in a couple of minutes plus created no disfigure, fumes or mess. The serviceman verified the results by way of a ipad program plus provided a certificate for a ten-year guarantee.